Dryer Runs but No Heat: A Troubleshooting Order That Saves Money

Dryer Runs but No Heat: A Troubleshooting Order That Saves Money

The drum is turning, the clothes are cold. This is one of the more straightforward repairs we do, because the possible causes are a short list.

Step 0: the breaker

Electric dryers run on a 240V double-pole breaker. One half can trip and leave the other half live. The drum and lights run on 120V, so the dryer looks alive but has no heat. Flip the breaker fully off and back on. This fixes more calls than you’d expect.

Step 1: the vent

Check airflow first (see our dryer vent post on this site if you need the details). A restricted vent trips safety thermostats, which then shut off the heat. In Huntington Beach, where a lot of laundry closets are tucked in garages or interior hallways, long vent runs are the norm.

Electric dryers: the usual suspects

Part What it does Typical part cost
Thermal fuse One-time safety cutoff $10 to $30
Heating element The coil that makes heat $40 to $100
High-limit thermostat Shuts off if too hot $15 to $40
Thermostat/cycling stat Regulates temp $15 to $40

A tech with a multimeter can test each for continuity in minutes. If the thermal fuse blew, find out why. It almost always means airflow.

Gas dryers: different parts

  • Igniter. Glows and fails to light, or doesn’t glow. Very common.
  • Gas valve coils. Two small solenoids that wear out. They’re cheap ($15 to $40) but the symptom looks like a bad igniter.
  • Flame sensor/thermal fuse. Same airflow story.

If you smell gas, stop, shut the valve, ventilate, and call. Do not keep running the dryer.

Salt air is a real thing here

If you’re near the coast, corrosion hits the terminals and wire connectors inside dryers. A loose or corroded connection at the heating element terminal can mimic a dead element. We see this a lot west of PCH.

Repair or replace?

Almost all of these are worth fixing on a dryer under 12 years old. A $200 repair beats $800 new. On an old, basic dryer with multiple issues, replacement can make more sense.

Quick answers

Why does my dryer spin but not heat? Tripped breaker, blown thermal fuse, bad element, or bad igniter.

Is it the same for gas and electric? The vent and safety parts are shared. The heat source is different.

Is it dangerous to keep running it? If it’s just cold, no. If it’s hot and smelling burnt, stop.

Call us if you’d like a straight answer on what’s wrong and what it’ll cost.

Keep exploring

Ready to get started?

(714) 243-8415

📞 (714) 243-8415